- ページ 9

サンダー Clarke Super 7RのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke Super 7R 17 ページ。 Dc edger
Clarke Super 7R にも：取扱説明書 (16 ページ), 操作と安全性 (2 ページ), マニュアル (6 ページ)

ページを印刷する

1. Parts and Service Manual - Section

OPERATING INSTRUCTIONS cont.

DANGER: Failure to disconnect the supply cable

from machine whenever servicing,

replacing abrasive, or emptying the

dust bag could result in electrocution

or severe injury. Never leave machine

unattended while the supply cable is

connected.

DANGER:

Never leave dust bag unattended with

sanding dust in it. Sanding dust can

spontaneously ignite and cause a fire

or explosion. Empty dust bag into a

metal container, clear of any combus

tibles. Do not empty content into a fire.

Do not overfill dust bag.

ADJUSTMENT PROCEDURES

Leveling

To level machine: Grasp caster adjusting screw "A" with an

appropriate tool (pliers ect.). Using a similar tool, loosen

locknut "B" with a counter clockwise motion. (Figure 5).

Condition - Pad creates ridges on both edges or a "hop" is

experienced: Rotate both adjusting screws equal amounts

clockwise. Tighten locknuts and test on a piece of ply-

wood. Repeat procedure until condition is corrected. We

recommend you not exceed 1/8" rotation for each attempt.

Condition - Pad creates a ridge on the tip of the pad:

Rotate both adjusting screws counter clockwise, tighten

locknuts and test. Repeat procedure until condition is

corrected. Use only 1/8 rotation for each attempt.

Condition - Pad creates a ridge on only one side of the pad:

Either rotate the adjusting screw of the side effected

clockwise or rotate theadjusting screw opposite counter-

clockwise, depending on whether the ridge terminates

beyond the tip of the pad or prior to it. If it is prior to the

tip, adjust the side effected, otherwise adjust the opposite

side.

ROUTINE MAINTENANCE

CAUTION: Failure to perform maintenance at

recommended intervals may void

warranty.

Carbon Brushes

Have the carbon brushes replaced at least every 500

hours and more frequently under heavy use.

Dust Bag

Periodically the dust bag should be turned inside out,

shaken vigorously and machine washed in cold water

to prevent pore blockage and loss of dust control.

Page 8

Figure 5

Bearings

To insure reliable performance, have armature and

pad driver bearings inspected for wear or damage

after every 1500 hours. If used heavily, have the

bearings replaced seasonally.

Lubrication

The machine comes fully lubricated. The gears in

the gear box have enough lubrication for approxi-

mately six months of normal operation. Have the

lubricant changed at least every 6 months or more

frequently under heavy use.

Clarke

American Sanders Super 7R Operator's Manual