- ページ 10

サンダー Clarke X-PRO CAT 160のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke X-PRO CAT 160 17 ページ。

DISCONNECTING THE AIR SUPPLY

1. Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air released.

2. Squeeze the trigger to discharge any compressed air from the sander and

air hose.

3. Once the pressure has been released, disconnect the air supply hose from

the sander.

WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE

AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES.

Please note that factors other than the tools condition may effect its operation

and efficiency, such as reduced compressor output, excessive drain on the

airline, moisture or restrictions in the air-line, or the use of connectors of

improper size or poor condition which will reduce air supply.

DAILY

1. Before use, drain water from the air-line and compressor.

2. Lubricate the air tool daily for optimum performance, using a high quality

airline oil either via a lubricator in the air supply system or by placing a few

drops into the air inlet immediately before use. This should be carried out

regardless of whether or not an in-line lubricator is used.

CLEANING

1. Keep the sander clean and free from debris.

2. Grit or gum deposits in the mechanism may eventually reduce efficiency.

This condition can be corrected by cleaning the air inlet filter and flushing

out the tool with gum solvent oil or an equal mixture of SAE No10 oil and

paraffin.

3. Failing this, the tool should be disassembled, thoroughly cleaned, dried

and reassembled. You may prefer to take the tool to your CLARKE dealer if

internal maintenance is required.

4. If the sander becomes sluggish and the air supply is of good quality, it may

be necessary to replace worn or damaged parts. You may prefer to take

the tool to your Clarke dealer if internal maintenance is required.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]