- ページ 8

サンダー Clarke X-PRO CAT 160のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke X-PRO CAT 160 17 ページ。

BEFORE USE

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR

COMPRESSORS AND A COMPRESSED AIR SUPPLY.

FITTING A SANDING DISC

1. Select the disc to be used which

MUST be 150mm diameter with

hook and loop backing.

2. Line up the holes in the disc with

those on the sanding pad. (This is

necessary for dust extraction

purposes). Press the disc firmly onto

the pad to secure it.

Ensure the compressor is turned off and that the trigger is NOT depressed when

connecting the air line to avoid inadvertent starting of the sander.

1. Remove the protective plug from

the air inlet and connect a suitable

hose with a male end fitting or use

the adaptor supplied to connect a

suitable hose.

2. Connect the other end of the hose

to the compressed air supply.

3. Turn on the air supply and check

for air leaks. Rectify any found

before proceeding.

• PTFE tape may be useful for sealing threaded connections.

4. If required, connect an in-line mini oiler to the tool. A mini oiler helps to

prolong the life of the air tool.

5. If a mini-oiler is not being used, run a few drops of oil through the tool

before use. It can be entered through the air inlet or via the hose at the

nearest connection to the air supply.

6. A gauze filter is fitted within the air inlet. Ensure this filter is always kept

clean. An airline can be connected to the adapter, via a quick release

coupling (not supplied).

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]