- ページ 5

水ポンプ Clarke BIP1500のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke BIP1500 17 ページ。 1” electric water pump

FITTING THE CABLE

Do not attempt electrical installation

work if you are in any doubt as to

how it should be done correctly.

Consult a qualified electrician.

The pump must be wired according

to the diagram, after removing the

cover plate, ensuring the following

principles are observed:

• The cable used must be the

correct size to ensure it is a tight

fit in the cable gland.

• Ensure the cable gland is

correctly used. The clamp must

firmly hold the outer cable

sheath and not the wires.

• Fit a crimp style ring terminal to

the earth wire and make sure

that it is correctly connected to

the earth terminal. The ring

terminal should be placed

between the two washers, and

the screw suitably tightened.

WARNING! THE WIRES IN THE POWER CABLE SHOULD BE

COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:

(Blue = Neutral

To ensure that the colours of the wires in the power cable correspond with the

markings on the terminals of your plug, proceed as follows.

he wire which is coloured Blue must be connected to the terminal

• T

which is marked N or coloured Black.

• The wire which is coloured Brown must be connected to the terminal

which is marked L or coloured Red.

• The wire which is coloured Yellow and Green must be connected to

the terminal which is marked E or

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Brown = Live

Yellow and Green = Earth

or coloured Green