ページを印刷する
High Pressure Lubricant Pump
Figure Pump Tubes 337384-Al, and Bl - Section View
9
10 Screw Coupling (15) [end without coun-
11 Secure the air motor assembly in a soft-jaw
12 Screw the Coupling assembly onto the
Pump Tube (Outer Components)
13 Install and seat Seal (29) [lips first] into the
14 Install and seat Bearing (30) into the bot-
15 Install Gasket (31) onto the top of Exten-
16 Screw the Extension [with Loctite 222]
17 Install Gasket ( 14 ) into the top of the
18 Install and seat Bearing (27) [small diam-
19 Screw Tube (26) [with Loctite 222] into
20 Install and seat Gasket (14) into Adapter
21 Screw the Tube assembly [with Loctite
22 Install O-Ring (12) onto the Adapter.
23 Apply grease to Piston ( 25 )
9
SER 8540-B
Screw Rod (18) into Coupling (19) until
the pin holes align.
• Install Pin (17).
ter-bore] onto the Rod until the pin holes
align.
• Install additional Pin (17).
vise.
air motor rod until the pin holes align.
• Install Pin (16).
bottom of Retainer (28). See Figure 2.
tom of the Retainer.
sion (32).
IMPORTANT: If a primer is used with
Loctite 222 , the curing time is greatly
reduced.
(Gasket end first) into the bottom of the
Retainer.
• Follow the thread sealant manufactur-
er's recommendations.
• Do not tighten at this.
retainer.
eter first] and additional Gasket (14) into
the top of the Retainer.
the top of the Retainer.
• Do not tighten at this time.
(13).
222] into the Adapter.
• Do not tighten at this time.
• This will aid the installation