- ページ 8

自動車バッテリー充電器 CTEK CHARGESTORM CONNECTED 2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CTEK CHARGESTORM CONNECTED 2 19 ページ。
CTEK CHARGESTORM CONNECTED 2 にも：ユーザーマニュアル (20 ページ)

ページを印刷する

Make sure that the green connector symbol on

the front panel activates.

To change the conﬁguration settings

NOTE: For most installations no change of the configuration is needed.

NOTE: CTEK E-Mobility recommends that the installation technician documents

the result of the configuration tests in the dedicated protocol.

If the computer runs on Microsoft Windows, Download the CCU Drivers

from the webbsite. Follow the instructions given on the webbsite.

NOTE: For Linux, Android and Mac OSX, the USB driver is part of the operating

system.

Connect the USB cable between the computer and the mini USB port on

the controller board.

Open the web browser and log in to the local web interface at

http://192.168.7.2

The user name and password are both "ccu".

NOTE: CTEK E-Mobility recommends web browser Chrome for this action.

User & installation instructions

To conﬁgure the network interface (Ethernet)

Navigate to Configuration>Interface>General and select WAN = Wire.

Navigate to Configuration>Interface.

Select Wire.

Select DHCP or Static. If Static is selected, also enter IP address, netmask

and gateway.

Press Save at the bottom of the page.

To conﬁgure WWAN (3G)

NOTE: WWAN is a specific 3G mode and is usually more robust than PPP.

Navigate to Configuration.

Select Interface.

General and select WAN = modem (WWAN)

Navigate to Configuration>Interface>WWAN and enter APN applicable for

the selected 3G operator. Leave remaining fields empty.

Press Save at the bottom of the page.

CTEK E-Mobility AB