- ページ 8
ソウ Clarke 6470162のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 6470162 17 ページ。 355mm abrasive cut-off saw
ページを印刷する
OPERATION
VICE OPERATION
1. Turn the handle counterclockwise
to remove clamping pressure.
2. Lift the vice lever up.
3. Pull handle out as far as desired.
• The vice may be pushed forward
into the work without turning the
handle.
4. Lower the vice lever then tighten the vice on to the work using the handle.
TRIGGER SWITCH
1. To start the saw, pull the trigger
switch.
• Wait a couple of seconds until
the cutting disc reaches full
speed.
2. To turn the saw off, release the
trigger switch.
• Keep hands and materials away
from the cutting disc until it has come to a complete stop.
TIPS FOR MORE ACCURATE CUTS
• Allow the cutting disc to do the cutting. Excessive force will cause
the cutting disc to glaze reducing cutting efficiency and/or to
deflect causing inaccurate cuts.
• Adjust the fence angle.
• Make sure the workpiece is laying flat across the base.
• Clamp the workpiece securely to avoid movement and vibration.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8