Clarke 6470162 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke 6470162에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6470162 17 페이지. 355mm abrasive cut-off saw

OPERATION

VICE OPERATION

1. Turn the handle counterclockwise

to remove clamping pressure.

2. Lift the vice lever up.

3. Pull handle out as far as desired.

• The vice may be pushed forward

into the work without turning the

handle.

4. Lower the vice lever then tighten the vice on to the work using the handle.

1. To start the saw, pull the trigger

switch.

• Wait a couple of seconds until

the cutting disc reaches full

speed.

2. To turn the saw off, release the

trigger switch.

• Keep hands and materials away

from the cutting disc until it has come to a complete stop.

• Allow the cutting disc to do the cutting. Excessive force will cause

the cutting disc to glaze reducing cutting efficiency and/or to

deflect causing inaccurate cuts.

• Adjust the fence angle.

• Make sure the workpiece is laying flat across the base.

• Clamp the workpiece securely to avoid movement and vibration.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]