- ページ 9

ソウ Clarke CSS16VのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CSS16V 15 ページ。 400mm (16") variable speed scroll saw

ページを印刷する

1. Blade Renewal

3. BEVEL ALIGNMENT

To align the bevel indicator, loosen the table bevel

lock knob, and level the table until it is at right

angles to the blade. Use a small square to be sure

that the angle between blade and table is 90

When the table is perpendicular to the blade,

tighten the bevel lock knob.

Loosen the screw holding the pointer, adjust the

pointer to 0

, then retighten the screw.

The bevel scale is a convenient indicator, but it is

not guaranteed to be 100% accurate. Where

absolute accuracy is required, always double

check with a protractor before starting a cut.

4. BLADE INSTALLATION / RENEWAL

4.1 Before installing or removing blades, turn OFF the saw and disconnect it from the

supply. Remove the blade as described in 2.

NOTE:

The blade slots and pin recesses are made so you can position the blade for cutting from

the front, or from the side (see figs. 3). Cutting from the side is necessary when your

workpiece is over 16" long.

IMPORTANT: Side cutting can only be performed when the table is level, i.e. set to 0

4.2 With the blade teeth pointing DOWNWARDS, slot the new blade into the lower

housing so that the pins on the end of the blade, engage in the recess in the

housing. Holding the blade firmly, apply downward pressure to the upper arm

whilst slotting the upper end of the blade into the slot in the upper housing, again,

making sure the blade pins correctly engage in the recess in the housing.

4.3 Replace the Table Insert, and re-tension to the blade, by turning the tension

knob clockwise until you feel the blade is firm. Check to ensure that the blade

pins are properly seated, top and bottom.

OPERATION

Ensure the machine is completely stable...either bolted to a workbench, or with the

mounting board clamped firmly to a workbench.

Ensure the table is perfectly secure and at the desired angle and the blade tensioned

correctly...ie. tight but not excessively so.

Plug in the mains cable and set the variable speed control to zero..fully anticlockwise.

Place the workpiece on the table and bring the Drop Foot into light contact with the

work surface, then tighten the securing screw.

Switch ON by pressing the green knob 'I'. Turn the variable speed control to a desired

speed....generally, the harder or thicker the wood, the slower the speed.

Feed the workpiece into the blade gently....do not force it. If there is a need to stop

cutting, switch OFF by pressing the red knob 'O', and allow the blade to stop

completely before gently working the blade out of the workpiece.

NOTE: A Dust Port is provided so that a vacuum extraction device may be used.

(see fig. 4)

Fig. 4