- ページ 7

ツール Clarke 6500101のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 6500101 12 ページ。 Pipe notcher

1. Remove the 2 hex bolts, as shown,

from the back of the body and

remove the spindle support from

the notcher.

2. Remove the spindle lock pin.

3. Thread the hole saw on to the

spindle by hand. Thread the 5/8"

adapter onto the spindle before

the hole saw if using a 5/8" hole

saw.

NOTE: For cutting steel pipe and

tubing, it is recommended to

use a bi-metal hole saw.

These can operate at up to 500rpm for most diameters and

should be operated at higher speeds for thin wall tubing.

4. Place workpiece into the clamp

of the notcher as shown, and

tighten the clamp until the

workpiece is secured.

5. Loosen the 2 adjusting angle hex bolts as

shown, adjust the clamp to the desired

angle, then tighten hex bolts.

6. Reattach the spindle support to the

notcher using the hex bolts removed in

step 1.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]