Clarke 6500101 Manual de Instruções de Operação e Manutenção - Página 7
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Ferramentas Clarke 6500101. Clarke 6500101 12 páginas. Pipe notcher
Imprimir página
1. Remove the 2 hex bolts, as shown,
from the back of the body and
remove the spindle support from
the notcher.
2. Remove the spindle lock pin.
3. Thread the hole saw on to the
spindle by hand. Thread the 5/8"
adapter onto the spindle before
the hole saw if using a 5/8" hole
saw.
NOTE: For cutting steel pipe and
tubing, it is recommended to
use a bi-metal hole saw.
These can operate at up to 500rpm for most diameters and
should be operated at higher speeds for thin wall tubing.
4. Place workpiece into the clamp
of the notcher as shown, and
tighten the clamp until the
workpiece is secured.
5. Loosen the 2 adjusting angle hex bolts as
shown, adjust the clamp to the desired
angle, then tighten hex bolts.
6. Reattach the spindle support to the
notcher using the hex bolts removed in
step 1.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7