- ページ 12

ツール Clarke CONTRACTOR 6462118のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CONTRACTOR 6462118 20 ページ。 Worktop jig

Post Form Edge

Position the jig onto the worktop to be cut into the male piece, referring back to the

instructions for cutting 90º joints. Subtract 228mm from the intended length,

e.g. 1000mm - 228mm = 772mm. Position the worktop jig 772mm from the opposite end

of the worktop you are cutting.

Fig. 14

Left Hand 45º Joints

Female joint (Fig. 15)

Prepare the worktop with the laminate face up and the post form edge towards

the left.

2. Fully insert 2 pins in the holes marked 'F'.

3. Position the jig as in Fig. 15 so that when the cut has been made, there is sufficient

length to enable trimming to length, see Fig. 16 over.

-11-

772mm

Pencil Line

Cut Direction

1000mm

- Refer to the diagrams on the different joints available.

Fig. 13