Clarke CONTRACTOR 6462118 Handleiding voor bediening en onderhoud - Pagina 12
Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke CONTRACTOR 6462118. Clarke CONTRACTOR 6462118 20 pagina's. Worktop jig
Pagina afdrukken
Post Form Edge
Position the jig onto the worktop to be cut into the male piece, referring back to the
instructions for cutting 90º joints. Subtract 228mm from the intended length,
e.g. 1000mm - 228mm = 772mm. Position the worktop jig 772mm from the opposite end
of the worktop you are cutting.
Fig. 14
Left Hand 45º Joints
Female joint (Fig. 15)
1.
Prepare the worktop with the laminate face up and the post form edge towards
the left.
2. Fully insert 2 pins in the holes marked 'F'.
3. Position the jig as in Fig. 15 so that when the cut has been made, there is sufficient
length to enable trimming to length, see Fig. 16 over.
-11-
772mm
Pencil Line
Cut Direction
1000mm
- Refer to the diagrams on the different joints available.
Fig. 13