- ページ 15
ツール Clarke CONTRACTOR 6462119のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CONTRACTOR 6462119 20 ページ。 Worktop jig
ページを印刷する
Male Bolt Recesses (Fig. 19)
18.
19. Fully insert 3 pins in the holes marked 'CB'.
20. Clamp the jig to the worktop ensuring all 3 pins are pushed firmly against the
worktop. Ensure clamps do not obstruct the router path.
21. Place the router into the front of one of the clamp bolt recesses, set the depth of
cut to 10mm max. Switch the router ON and machine the recess. When done,
switch the router OFF and wait for the cutter to stop spinning. Return the router to
the back again. Increase the depth of cut a further 10mm and machine the recess
again. When finished, switch the router OFF and wait for it to stop spinning.
22. Repeat step 21 for the other 2 recesses (other 3 recesses for 900mm worktops).
Recesses must be no deeper than 20mm maximum.
Right Hand 45º Joints
Female joint (Fig. 20)
1.
Prepare the worktop with the laminate face down and the post form edge towards
the left.
2. Fully insert 2 pins in the holes marked 'F'.
3. Position the jig as in Fig. 15 so that when the cut has been made, there is sufficient
length to enable trimming to length, see Fig. 16 page 12.
4. Ensure the 2 pins in holes 'F' are pushed firmly against the post form edge of the
worktop, clamp the jig to the worktop ensuring clamps do not obstruct the router
path.
5. Once the cut is complete, cut off the excess, see Fig. 16.
Cutting
6.
- Follow steps 6 - 9 on page 6.
To Prevent damage to the laminate surface, take
extra care when working with laminate face down.
- Place the worktop with laminate face down.
Male bolt recesses -
Laminate face down.
IMPORTANT
- Refer to the diagrams on the different joints available.
CAUTION
Post Form Edge
Fig. 19
-14-