- ページ 17

ツール Clarke CONTRACTOR 6462119のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CONTRACTOR 6462119 20 ページ。 Worktop jig

Fig. 22

Female Bolt Recesses (Fig. 18)

13.

14. Fully insert three pins in holes marked 'CB'.

15. Clamp the jig to the worktop ensuring the three pins are firmly pushed up to the cut

out face and the worktop edge. Ensure clamps do not obstruct the router path.

16. Place the router into the front of one of the clamp bolt recesses, set the depth of

cut to 10mm max. Switch the router ON and machine the recess. When done,

switch the router OFF and wait for the cutter to stop spinning. Return the router to

the back again. Increase the depth of cut a further 10mm and machine the recess

again. When finished, switch the router OFF and wait for it to stop spinning.

17. Repeat step 16 for the other 2 recesses (other 3 recesses for 900mm worktops).

Recesses must be no deeper than 20mm maximum.

Male Bolt Recesses (Fig. 23)

18.

Fig. 23

Female bolt recesses - Laminate face down.

- Place the worktop with the laminate face down.

IMPORTANT

- Place the worktop with laminate face down.

Male bolt recesses -

Laminate face down.

Post Form Edge

-16-