- ページ 6

ツール Clarke CONTRACTOR 6462119のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CONTRACTOR 6462119 20 ページ。 Worktop jig

Standard Joints

Corner joint

using left

and

right 45º joints

Before commencing, prepare the router by removing the fence guide etc if fitted, attach

the 30mm guide bush and if available, a dust extractor, also install the cutter. Put the

router safely to one side until ready to use.

Left Hand 90º Joints

Female joint (Fig. 4)

form (curved edge) towards you.

2. Fully insert three pins in the holes marked 'F'.

3 . Fully insert fourth pin in the hole corresponding to the worktop width (e.g.700mm).

NOTE: when inserting pins, ensure the heads finish up below the jig surface,

otherwise the router will not sit flat on the jig resulting in ill fitting joints.

Post Form Edge

Cut Direction

-5-

90º Left

Hand Joint

45º Right

Hand Joint

- prepare the worktop with laminate face up and the post

Female joint - laminate face up.

45º Left

Hand Joint

Fig. 3

Fig. 4

90º Right

Hand Joint