Clarke CONTRACTOR 6462119 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CONTRACTOR 6462119에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR 6462119 20 페이지. Worktop jig

Standard Joints

Corner joint

using left

and

right 45º joints

Before commencing, prepare the router by removing the fence guide etc if fitted, attach

the 30mm guide bush and if available, a dust extractor, also install the cutter. Put the

router safely to one side until ready to use.

Left Hand 90º Joints

Female joint (Fig. 4)

form (curved edge) towards you.

2. Fully insert three pins in the holes marked 'F'.

3 . Fully insert fourth pin in the hole corresponding to the worktop width (e.g.700mm).

NOTE: when inserting pins, ensure the heads finish up below the jig surface,

otherwise the router will not sit flat on the jig resulting in ill fitting joints.

Post Form Edge

Cut Direction

-5-

90º Left

Hand Joint

45º Right

Hand Joint

- prepare the worktop with laminate face up and the post

Female joint - laminate face up.

45º Left

Hand Joint

Fig. 3

Fig. 4

90º Right

Hand Joint