- ページ 11

ツール Clarke Metalworker CPTN1のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke Metalworker CPTN1 12 ページ。 Pipe notcher

4. Open drill chuck jaws and place

chuck onto the notcher spindle,

making sure the chuck jaws align

with the flat sides of the notcher

spindle, then tighten the chuck

jaws to secure.

5. Remove spindle lock pin from the spindle and rotate the drill chuck by

hand to test how easily the whole assembly turns.

NOTE: If assembly turns with minimal effort, proceed to step 6.

NOTE: If assembly does not turn with minimal effort, adjust the angle of

the drill until it does, then proceed to step 6.

NOTE: Failure to align the spindle flats properly with the chuck jaws may

result in the spindle coming loose and damaging the notcher and

drill chuck.

6. With the lock pin removed, apply cutting fluid, turn drill On and perform the

notching procedure.

ACCESSORIES

• Clarke CHT576 - 6pc Plumbers Hole Saw Set, Part No: 1801576

• Clarke CHT575 - 6pc Electricians Hole Saw Set, Part No: 1801575

• Clarke CDP5EB - Drill Press, Part No: 6550030

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]