Clarke Metalworker CPTN1 Handleiding voor bediening en onderhoud - Pagina 11
Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke Metalworker CPTN1. Clarke Metalworker CPTN1 12 pagina's. Pipe notcher
Pagina afdrukken
4. Open drill chuck jaws and place
chuck onto the notcher spindle,
making sure the chuck jaws align
with the flat sides of the notcher
spindle, then tighten the chuck
jaws to secure.
5. Remove spindle lock pin from the spindle and rotate the drill chuck by
hand to test how easily the whole assembly turns.
NOTE: If assembly turns with minimal effort, proceed to step 6.
NOTE: If assembly does not turn with minimal effort, adjust the angle of
the drill until it does, then proceed to step 6.
NOTE: Failure to align the spindle flats properly with the chuck jaws may
result in the spindle coming loose and damaging the notcher and
drill chuck.
6. With the lock pin removed, apply cutting fluid, turn drill On and perform the
notching procedure.
ACCESSORIES
• Clarke CHT576 - 6pc Plumbers Hole Saw Set, Part No: 1801576
• Clarke CHT575 - 6pc Electricians Hole Saw Set, Part No: 1801575
• Clarke CDP5EB - Drill Press, Part No: 6550030
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11