- ページ 6

試験装置 CTR Group Proch OneのPDF 使用とメンテナンスのハンドブックをオンラインで閲覧またはダウンロードできます。CTR Group Proch One 10 ページ。

WARNING: All filling and topping up operations must be carried out when PROCHONE is

disconnected from the supply line. Avoid use near open flame and contact with heat.

Ill. 4

• Connect the supply cable connector to the joint at the back of the unit

• Connect black and red pliers to the positive and negative poles of the battery respectively.

WARNING: PROCHONE only works at 12V direct current

Ill. 5

• Turn pressure regulator on the control board counter-clockwise completely.

WARNING: Starting PROCHONE with the flow regulator turned clockwise can damage the

A/C components (the system can deliver up to 12 bar).

• Check that the taps on the universal adapters are completely open

• Start PROCHONE by pressing the green switch (I) of the (O/I) main switch on the control

board

WARNING: splashes of product could come in contact with overheated parts. Protect all

overheated parts and wait for them to cool down

• Check for any leakage in the hydraulic connections.

• Increase pressure by rotating the pressure regulator clockwise (Ill. 5) so that it reaches

correct values

• 7/8 bar: Hoses or hydraulic connections

• 7/8 bar: A/C system components (condensers, evaporators, piping)

• If pressure strives to reach wanted values, operate on the blue hose tap (outlet) until you

obtain recommended pressure.

• Leave process on for about 20 min.

• Turn PROCHONE off by pressing the red switch (I) of the (O/I) main switch on the

control board

Ill. 6

• Start clearing of Proch One

• Screw fitting with yellow tap (supplied with PROCHONE) into the "AIR IN" fitting on

the control board.

• Check that the tap is closed

• Connect compressed air hose to the fitting you just screwed in

• Open yellow tap gently and keep it open until the hydraulic circuit of Proch One is

completely cleared

• This way all the liquid in the circuit of Proch One will be collected inside the tank

• Close compressed air inlet yellow tap.

• Disconnect supply cable from the battery of the vehicle

• Disconnect compressed air hose