- ページ 23
デスクトップ Lenovo ThinkCentre M91pのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Lenovo ThinkCentre M91p 38 ページ。 Intel active management technology configuration guide
Lenovo ThinkCentre M91p にも： 仕様 (5 ページ), 配備マニュアル (34 ページ), お知らせ (6 ページ)
ページを印刷する
Periodic Update Interval
TTL
TCP/IP Settings
Select TCP/IP Settings and press Enter. The TCP/IP SETTINGS window opens. The following options
will be displayed:
•
"Wired LAN IPV4 Configuration" on page 15
•
"Wired LAN IPV6 Configuration" on page 15
Wired LAN IPV4 Configuration
Select Wired LAN IPV4 Configuration ➙ DHCP Mode. The DHCP Mode option is used to enable or
disable DHCP mode. With DHCP mode enabled, the TCP/IP settings will be configured by a DHCP server.
With DHCP mode disabled, the options in the following table will be displayed. You will be required to
configure the static TCP/IP settings for the Intel AMT computer. If the system is in static mode, a second
IP address is required. This second IP address is often called the Intel ME IP address and is different
from the host IP address.
IPV4 Address
Subnet Mask Address
Default Gateway Address
Preferred DNS Address
Alternate DNS Address
Wired LAN IPV6 Configuration
Select Wired LAN IPV6 Configuration and press Enter. The WIRED LAN IPV6 CONFIGURATION window
opens.
Option
Option
.
Chapter 4
Intel AMT setup and configuration on Lenovo ThinkCentre M91p desktop computers
Description
Enables you to set the interval between every two
successional updates that the Dynamic DNS Update
Client in the firmware sends to the DNS.
Notes:
1. The Periodic Update Interval option is only available
when the Dynamic DNS Update feature is enabled.
2. The interval unit is minute. The interval value should
be zero or no smaller than 20. By setting the interval
value to zero, you disable the periodic update feature.
Enables you to set the Time To Live (TTL) value in
seconds.
Notes:
1. The TTL option is only available when the Dynamic
DNS Update feature is enabled.
2. The TTL value should be greater than zero. If the TTL
value is set to zero, the firmware will use the default
value, which is 900 seconds.
Description
Enables you to enter the Intel ME IP address for your Intel
AMT computer.
Enables you to enter the subnet mask address for your
Intel AMT computer.
Enables you to enter the default gateway address for your
Intel AMT computer.
Enables you to enter the preferred DNS address for your
Intel AMT computer.
Enables you to enter the alternate DNS address for your
Intel AMT computer.
15