- ページ 5

クワッドコプター Blade Blade 180QX HDのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Blade Blade 180QX HD 20 ページ。
Blade Blade 180QX HD にも：取扱説明書 (20 ページ)

Installing the Landing Gear

Install the landing gear using the

four included screws.

Replace the transmitter batteries when the power LED ﬂ ashes and the

transmitter beeps.

1. Lower the throttle and throttle trim to the lowest settings.

2. Power on the transmitter.

3. Install the battery by sliding it into the battery mounting slot below the 5-in-1 control unit. Slide the battery into the

slots with the label facing upward so that the battery key molded into the battery end-cap comes in contact with

the key on the battery slot.

4. Connect the battery cable to the 5-in-1 control unit.

5. Place the quadcopter on its skids on a ﬂ at surface and leave the aircraft still until the LED on the 5-in-1 control unit

is solid blue (not blinking)

CAUTION: Always disconnect the Li-Po battery from the aircraft when not ﬂ ying to avoid over-discharging the

battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,

resulting in loss of performance and potential ﬁ re when batteries are charged.