Blade Blade 180QX HD 사용 설명서 - 페이지 5

{카테고리_이름} Blade Blade 180QX HD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blade Blade 180QX HD 20 페이지.
Blade Blade 180QX HD에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

Installing the Landing Gear

Install the landing gear using the

four included screws.

Replace the transmitter batteries when the power LED ﬂ ashes and the

transmitter beeps.

1. Lower the throttle and throttle trim to the lowest settings.

2. Power on the transmitter.

3. Install the battery by sliding it into the battery mounting slot below the 5-in-1 control unit. Slide the battery into the

slots with the label facing upward so that the battery key molded into the battery end-cap comes in contact with

the key on the battery slot.

4. Connect the battery cable to the 5-in-1 control unit.

5. Place the quadcopter on its skids on a ﬂ at surface and leave the aircraft still until the LED on the 5-in-1 control unit

is solid blue (not blinking)

CAUTION: Always disconnect the Li-Po battery from the aircraft when not ﬂ ying to avoid over-discharging the

battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,

resulting in loss of performance and potential ﬁ re when batteries are charged.