- ページ 3

カー・ステレオ・システム Discount Car Stereo A2DIY-CR12のPDF クイック・スタート・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Discount Car Stereo A2DIY-CR12 8 ページ。 Bluetooth add-on module for porsche cr-1 and cr-2 radios

ページを印刷する

2. Connect supplied 3.5mm audio cable (See Fig. 3) to module "AUX" jack

(See Fig. 4). Route audio cable other end to dash area or wherever Aux

device will reside (within 3 ft.)

Fig. 3

Audio cable

Fig. 4

Module

3. Secure visor microphone (See Fig. 5) to visor or headliner using included

visor clip (See Fig. 6)

Fig. 5

Microphone

4. Route microphone cable down pillar, under steering column and into

radio cavity.

5. Connect microphone plug to Module "MIC" input jack (See Fig. 4)

Be cautious not to damage or cut both microphone cable.

6. Porsche CR-1 and CR-2 radios have two possible wiring configuarions

7. CR-1/CR-2 radios with 8-pin ISO:

8. Connect power harness 8-pin plug (See Fig. 8) to radio 8-pin connector

Fig. 6

Visor clip

9. CR-1/CR-2 radios with 5-pin plug (See Fig. 7): Cut red wire from

10. Discard power harness (See Fig. 8)

that varies based on vehicle (See Fig. 7). The A2DIY-CR12 module ships

with power harness seen in Fig. 8

Module accessory wire (power) connection:

- Radios with 8-pin iso plugs (See Fig. 7) proceed to step 7

- Radios

with 5-pin power plug proceed to step 9

5-pin plug

Fig. 7

Radio plugs

Disconnect factory 8-pin plug from radio and mate with to 8-pin

connector on power harness. (See Fig. 8)

vacated in step 7 (See Fig.7)

Fig. 8

Power harness

power harness (See Fig. 8) and tap to ACC (GREEN) wire on 5-pin plug

seen in Fig. 7 (color may vary but pin position remain the same)

Proceed to "Pairing" section on page 6

8-pin ISO plug