Discount Car Stereo A2DIY-CR12 Skrócona instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja instalacji dla Samochodowy system stereo Discount Car Stereo A2DIY-CR12. Discount Car Stereo A2DIY-CR12 8 stron. Bluetooth add-on module for porsche cr-1 and cr-2 radios
Drukuj stronę2. Connect supplied 3.5mm audio cable (See Fig. 3) to module "AUX" jack
(See Fig. 4). Route audio cable other end to dash area or wherever Aux
device will reside (within 3 ft.)
Fig. 3
Audio cable
Fig. 4
Module
3. Secure visor microphone (See Fig. 5) to visor or headliner using included
visor clip (See Fig. 6)
Fig. 5
Microphone
4. Route microphone cable down pillar, under steering column and into
radio cavity.
5. Connect microphone plug to Module "MIC" input jack (See Fig. 4)
Be cautious not to damage or cut both microphone cable.
6. Porsche CR-1 and CR-2 radios have two possible wiring configuarions
7. CR-1/CR-2 radios with 8-pin ISO:
8. Connect power harness 8-pin plug (See Fig. 8) to radio 8-pin connector
Fig. 6
Visor clip
9. CR-1/CR-2 radios with 5-pin plug (See Fig. 7): Cut red wire from
10. Discard power harness (See Fig. 8)
that varies based on vehicle (See Fig. 7). The A2DIY-CR12 module ships
with power harness seen in Fig. 8
Module accessory wire (power) connection:
- Radios with 8-pin iso plugs (See Fig. 7) proceed to step 7
- Radios
with 5-pin power plug proceed to step 9
5-pin plug
Fig. 7
Radio plugs
Disconnect factory 8-pin plug from radio and mate with to 8-pin
connector on power harness. (See Fig. 8)
vacated in step 7 (See Fig.7)
Fig. 8
Power harness
power harness (See Fig. 8) and tap to ACC (GREEN) wire on 5-pin plug
seen in Fig. 7 (color may vary but pin position remain the same)
Proceed to "Pairing" section on page 6
8-pin ISO plug