- ページ 11

自動車アクセサリー Discount Car Stereo BLU-C5のPDF インストール手順をオンラインで閲覧またはダウンロードできます。Discount Car Stereo BLU-C5 12 ページ。 Music streaming module for seelect 1997-04 corvette
Discount Car Stereo BLU-C5 にも：インストレーション・マニュアル (9 ページ), 取付説明書 (12 ページ), インストレーション・マニュアル (10 ページ), インストレーション・マニュアル (8 ページ), インストレーション・マニュアル (12 ページ)

ページを印刷する

Frequent asked questions

Does the BLU-C5 require the 12-disc CD changer to work?

NO;

CD changer not required and if present will need to be disconnected. To

retain 12-disc changer functionality; purchase our

2. Why does this kit not include a microphone (Does it not support

Bluetooth hands-free calls)?

NO;

BLU-C5 module supports Bluetooth music streaming only. For Bluetooth

hands-free purchase our

A2DIY-C5CD

3. Can I install the BLU-C5 without removing radio?

YES;

If vehicle has a 10-pin plug (See Fig. 6) in trunk/hatch, it can be used

as the connecting point for the BLU-C5. Factory 12-disc changer (if present);

must be disconnected. For this install you must select PXHGM2

installation harness from product page.

4. Streaming is interrupted when using turn signal, headlights or wipers,

Do I have a defective module?

In rare occasions users may experience streaming interruptions when

using these accessories, but if you do the accessory (e.g. wiper motor etc.)

is loading down the circuit to which the BLU-C5 is connected. Please locate

alternate ACC supply for module.

5. Ignition switch is "ON" but blue LED is not flashing. Why is that?

Check ACC wire for power (Go to page 5). Also check Add-a-fuse crimp

integrity; often times a bad crimp may result in lack of power.

6. Nothing changes when pressing radio "AUX" button. What would cause

this?

Ensure only dip-switch #3 and 8 are "ON" or down, otherwise try resetting:

1. Disconnect 22-pin plug from module or disconnect battery terminal

(one or the other)

2. Set all 8 dip-switches to "OFF" or "UP"

3. Module or battery must remain disconnected for 5-10 minutes

4. After time has expired, set dip-switches 3 and 8 to "ON or down

5. Reconnect 22-pin plug to module or reconnect negative battery terminal

6. Turn ignition to ACC and radio "ON", press AUX button. If all went well,

radio display should change to Disc 1 Track 1.

Warning: Set Dip switches prior to reconnecting module or battery

terminal, otherwise you will have to repeat steps 1-6

A2D-C5

instead.

C5CD-HF

or our

A2DIY-C5

C5-

7. It is possible to install the BLU-C5 at radio instead of trunk/hatch?

YES;

select the PXHGM4 or PXHGM4 with USB installation harness from

product page.

8. Why do I have to connect an accessory wire to fuse box. Is there not

an accessory wire at the radio or CD changer plug?

Short answer is NO. As of 4/6/20 (revision); routing accessory wire is

no longer required for modules installed at the radio with PXHGM4 and

PXHGM4+ USB harnesses. The revised module does not require routing

accessory wire to fuse panel and will turn on/off with radio PWR button

which means module will continue playing even after ignition has been

turned off. Modules installed to 10-pin plug in trunk/hatch with PXHGM2

harness, requires routing accessory wire to fuse panel below passenger

toe board.

9. Can I connect the accessory wire to radio fuse (15A) which appears to

powers on/off with ignition switch?

NO! Radio fuse (5) is battery powered and not recommended. Radio ON/OFF

is controlled by BCM, (See question 12). Please refer to recommended fuse

positions for Acc. Wire on pg. 3 of this guide.

10. How do I remove radio from dashboard?

Please click video links below for help removing radio:

https://www.youtube.com/watch?v=Gcrlufo1ctc

https://www.youtube.com/watch?v=WTbWYNJTSDs

11. With ignition switch "OFF", radio remain powered but not able to

stream, why is that?

GM Retain Accessory Power (RAP) feature allows some accessories to

remain powered for up to 10 minutes after ignition switch is turned OFF or

until driver's door is opened, our module does not work with RAP, however

revision (4.6.20) with PXHGM4 or PXHGM4 +USB installation

harnesses include a special circuit allowing module to turn ON/OFF with

radio PWR button and as a result music streaming remains active even

after ignition is switched OFF. In addition,

Revision 4.6.20 DOES NOT apply to PXHGM2 installations in

trunk/hatch (these require connecting ACC. wire to fuse panel).