Discount Car Stereo BLU-C5 Installatie-instructies - Pagina 11
Blader online of download pdf Installatie-instructies voor {categorie_naam} Discount Car Stereo BLU-C5. Discount Car Stereo BLU-C5 12 pagina's. Music streaming module for seelect 1997-04 corvette
Ook voor Discount Car Stereo BLU-C5: Installatiehandleiding (9 pagina's), Handleiding voor installatie-instructies (12 pagina's), Installatiehandleiding (10 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (12 pagina's)
Pagina afdrukken
Frequent asked questions
1.
Does the BLU-C5 require the 12-disc CD changer to work?
NO;
CD changer not required and if present will need to be disconnected. To
retain 12-disc changer functionality; purchase our
2. Why does this kit not include a microphone (Does it not support
Bluetooth hands-free calls)?
NO;
BLU-C5 module supports Bluetooth music streaming only. For Bluetooth
hands-free purchase our
A2DIY-C5CD
HF
3. Can I install the BLU-C5 without removing radio?
YES;
If vehicle has a 10-pin plug (See Fig. 6) in trunk/hatch, it can be used
as the connecting point for the BLU-C5. Factory 12-disc changer (if present);
must be disconnected. For this install you must select PXHGM2
installation harness from product page.
4. Streaming is interrupted when using turn signal, headlights or wipers,
Do I have a defective module?
In rare occasions users may experience streaming interruptions when
using these accessories, but if you do the accessory (e.g. wiper motor etc.)
is loading down the circuit to which the BLU-C5 is connected. Please locate
alternate ACC supply for module.
5. Ignition switch is "ON" but blue LED is not flashing. Why is that?
Check ACC wire for power (Go to page 5). Also check Add-a-fuse crimp
integrity; often times a bad crimp may result in lack of power.
6. Nothing changes when pressing radio "AUX" button. What would cause
this?
Ensure only dip-switch #3 and 8 are "ON" or down, otherwise try resetting:
1. Disconnect 22-pin plug from module or disconnect battery terminal
(one or the other)
2. Set all 8 dip-switches to "OFF" or "UP"
3. Module or battery must remain disconnected for 5-10 minutes
4. After time has expired, set dip-switches 3 and 8 to "ON or down
5. Reconnect 22-pin plug to module or reconnect negative battery terminal
6. Turn ignition to ACC and radio "ON", press AUX button. If all went well,
radio display should change to Disc 1 Track 1.
Warning: Set Dip switches prior to reconnecting module or battery
terminal, otherwise you will have to repeat steps 1-6
A2D-C5
instead.
or
C5CD-HF
or our
A2DIY-C5
or
C5-
7. It is possible to install the BLU-C5 at radio instead of trunk/hatch?
YES;
select the PXHGM4 or PXHGM4 with USB installation harness from
product page.
8. Why do I have to connect an accessory wire to fuse box. Is there not
an accessory wire at the radio or CD changer plug?
Short answer is NO. As of 4/6/20 (revision); routing accessory wire is
no longer required for modules installed at the radio with PXHGM4 and
PXHGM4+ USB harnesses. The revised module does not require routing
accessory wire to fuse panel and will turn on/off with radio PWR button
which means module will continue playing even after ignition has been
turned off. Modules installed to 10-pin plug in trunk/hatch with PXHGM2
harness, requires routing accessory wire to fuse panel below passenger
toe board.
9. Can I connect the accessory wire to radio fuse (15A) which appears to
powers on/off with ignition switch?
NO! Radio fuse (5) is battery powered and not recommended. Radio ON/OFF
is controlled by BCM, (See question 12). Please refer to recommended fuse
positions for Acc. Wire on pg. 3 of this guide.
10. How do I remove radio from dashboard?
Please click video links below for help removing radio:
https://www.youtube.com/watch?v=Gcrlufo1ctc
https://www.youtube.com/watch?v=WTbWYNJTSDs
11. With ignition switch "OFF", radio remain powered but not able to
stream, why is that?
GM Retain Accessory Power (RAP) feature allows some accessories to
remain powered for up to 10 minutes after ignition switch is turned OFF or
until driver's door is opened, our module does not work with RAP, however
revision (4.6.20) with PXHGM4 or PXHGM4 +USB installation
harnesses include a special circuit allowing module to turn ON/OFF with
radio PWR button and as a result music streaming remains active even
after ignition is switched OFF. In addition,
.
Revision 4.6.20 DOES NOT apply to PXHGM2 installations in
trunk/hatch (these require connecting ACC. wire to fuse panel).