- ページ 6
アクセサリー Cub Crafters CC11-160のPDF サービス指導をオンラインで閲覧またはダウンロードできます。Cub Crafters CC11-160 8 ページ。 Aft seat strap routing
Cub Crafters CC11-160 にも： 通知マニュアル (3 ページ)
ページを印刷する
SERVICE INSTRUCTION
d. "GND" post,
i. Remove and discard 2 flat washers, retain nut.
ii. Install other end of Radio Frequency Filter Assembly.
iii. Install A10B20O.
iv. Install lock washer.
v. Reinstall nut.
6. Mount sensor module
a. Place sensor module flange on outboard side of ignition module bracket and fasten
with 8-32 x 3/8 screw, washer, and nut.
b. Use tube clamp, AN742D12, 8-32 x 1/2 screw, washer and nut to secure the lower
flange of the sensor to the fuselage. If desired, cushion clamp with friction tape
wrapped around fuselage.
c. See Hardware Detail Figure below.
7. Route wires,
a. Route wire A10A20O from "+14V" post up to main bus. Connect to EFIS or INSTR
circuit breaker LINE.
b. Route wire A10B20O to ground bus behind instrument panel and connect.
c. Route A10C20O and A10D20O to amber warning LED in instrument panel, do not
connect yet.
Form #: EN-551
SI0024 Rev NC
Page 6 of 8
03-02-2010