- ページ 5

アクセサリー Cub Crafters CC11-160のPDF サービス指導をオンラインで閲覧またはダウンロードできます。Cub Crafters CC11-160 8 ページ。 Aft seat strap routing
Cub Crafters CC11-160 にも： 通知マニュアル (3 ページ)

ページを印刷する
Cub Crafters CC11-160 サービス指導
SERVICE INSTRUCTION
4. Suggestion: tape a piece of paper to the inside of the boot cowl that will redirect any dropped
hardware inside onto the floor and keep it from sliding down the inside of the boot cowl where
access is difficult.
5. Prepare sensor module
a. "OV TEST" post
i. Remove and discard top nut and 2 flat washers.
b. "+14V" post,
i. Remove and discard 2 flat washers, retain nut.
ii. Install one end of Radio Frequency Filter Assembly, SC56080-001.
iii. Install A10A20O and A10C20O through boot, MS25171-1S.
iv. Install lock washer, AN936-A6.
v. Reinstall nut.
c. "LAMP" post,
i. Remove and discard 2 flat washers.
ii. Install A10D20O.
iii. Install lock washer.
iv. Reinstall nut.
Form #: EN-551
SI0024 Rev NC
Page 5 of 8
03-02-2010