Cub Crafters CC11-160 서비스 지침 - 페이지 5

{카테고리_이름} Cub Crafters CC11-160에 대한 서비스 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Crafters CC11-160 8 페이지. Aft seat strap routing
Cub Crafters CC11-160에 대해서도 마찬가지입니다: 알림 매뉴얼 (3 페이지)

페이지 인쇄
Cub Crafters CC11-160 서비스 지침
SERVICE INSTRUCTION
4. Suggestion: tape a piece of paper to the inside of the boot cowl that will redirect any dropped
hardware inside onto the floor and keep it from sliding down the inside of the boot cowl where
access is difficult.
5. Prepare sensor module
a. "OV TEST" post
i. Remove and discard top nut and 2 flat washers.
b. "+14V" post,
i. Remove and discard 2 flat washers, retain nut.
ii. Install one end of Radio Frequency Filter Assembly, SC56080-001.
iii. Install A10A20O and A10C20O through boot, MS25171-1S.
iv. Install lock washer, AN936-A6.
v. Reinstall nut.
c. "LAMP" post,
i. Remove and discard 2 flat washers.
ii. Install A10D20O.
iii. Install lock washer.
iv. Reinstall nut.
Form #: EN-551
SI0024 Rev NC
Page 5 of 8
03-02-2010