- ページ 8

おもちゃ 3D Creations North American P 51 D MustangのPDF 組立説明書をオンラインで閲覧またはダウンロードできます。3D Creations North American P 51 D Mustang 15 ページ。 Paper scale model kit

ページを印刷する

3D Creations North American P 51 D Mustang 組立説明書

spars and butt them together. Cut out parts #16 and 17. Glue part #17 over the seam

between the two wings. Trim the edges if necessary. Flip the wing over and check the

dihedral. It should be right at one inch. See figure 24. Glue part #16 over the seam on the

top of the wings making sure you hold that 1 inch dihedral while doing it. Trim off any

excess that might hang off at the edges.

Mounting the Wing

First prepare the fuselage for the wing by folding in all the glue tabs on the wing mount

section of the fuselage.

Do not apply glue at this time.

It is also necessary to carefully

fold back

(with no crease)

the end of part # 22 to allow the landing gear strut to pass by.

This step is not necessary if the gear is not present.

Carefully slide the wing through the

wing mount area on the fuselage. This is

intentionally a tight fit. Use patience and be

gentile completing this task. After checking the

alignments to insure that wing is centered and

squares with the fuselage apply glue to the tabs

inside the fuselage. This is accomplished by

using liquid glue and a modeling paintbrush

extended into the nose and tail holes in the

fuselage. Apply glue to the underneath side of

part #22 and lay it back down into place. Cut out

parts #13. Double check the alignment and glue

these parts to the fuselage and wing as shown in

figure 25.