- ページ 12

おもちゃ 3D Hobby Shop 57" Extra 330 SCのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3D Hobby Shop 57" Extra 330 SC 16 ページ。

The firewall of the Extra is arranged to allow the widest possible selection of motors to fit. Extra space

has been provided for long motors and long prop adaptors. For this reason, if your motor is compact, you

will need to supply spacers to extend the motor forward as shown. Attach the motor using the included

4mms screws and blind nuts, using loctite. Mount your ESC to the side of the motor-mounting box.

The cowl is mounted onto the fuselage with 4 wood screws. These screws go into the small plywood

squares on the front inside of the fuselage. Soak these squares in thin CA glue to harden them before

proceeding.

The following procedure is helpful to be sure the wood screws hit the plywood squares.

First, make small holes into the plywood squares through the covering, with the cowl and canopy off.

Tape small pieces of paper over these holes, as shown, and mark the hole locations on these pieces of

paper.

Install the canopy hatch (if the canopy hatch is not installed when you fit the cowl, it may be

impossible to fit the canopy hatch after the cowl is installed!).