- ページ 14

おもちゃ 3D Hobby Shop 57" Extra 330 SCのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3D Hobby Shop 57" Extra 330 SC 16 ページ。

On the bottom of the wings, locate the servo cutout and aileron control horn slot. Remove the covering

over both. Glue the horn into the slot with a generous amount of medium or thick CA. Use the string in

the wing to pull the servo wire through the wing.

Assemble the aileron pushrods. Assemble the pushrod connectors onto the servo arm as you did for the

elevator and rudder arms, and install the pushrod as shown. Be sure to use medium CA glue to lock the

2mm nut that holds the ball link onto the control horn. Repeat for other wing. Mount the wings to the

fuselage using the black nylon thumbscrews.

Locate the balsa receiver mount marked "Rx". You can mount your receiver to this mount with Velcro and

use CA glue to mount the balsa to the airframe.

Apply one side of the self-adhesive Velcro tape to the battery tray, the other to your battery. Use the

Velcro strap as a "seatbelt" to hold your battery in position. Always make sure your battery is firmly

strapped down before flight.

Your Extra SC includes optional Side-Force-Generators (SFG's) for the wingtips. Install them as shown

with the spacers in-between the SFG and the tip. It is a good idea to use thin CA glue to harden the

screw holes in the wingtips, this will allow you to remove and insert the SFG screws many times.