- ページ 8
おもちゃ 3D Hobby Shop 70 AJ SLICKのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3D Hobby Shop 70 AJ SLICK 19 ページ。
ページを印刷する8
Using plenty of epoxy or polyurethane glue, install the rudder horns as shown, on both sides of the
rudder. Use the ball-joint and pull-cable end, as shown, to hold the rudder horn in perfect alignment while
the glue dries. Clean up any excess glue with alcohol. Allow to dry.
A NOTE about servo arms on the 70" Slick. The Slick uses ball-links on its controls for precise control-
surface motion. It is extremely important to make sure that the ball-links have free motion throughout the
servo travel, and do not touch the servo arms. For example, when using Hitec servo arms, this is easily
accomplished by cutting or sanding away the corner of the arm as shown.