3D Hobby Shop 70 AJ SLICK Instrukcja montażu - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zabawka 3D Hobby Shop 70 AJ SLICK. 3D Hobby Shop 70 AJ SLICK 19 stron.

Using plenty of epoxy or polyurethane glue, install the rudder horns as shown, on both sides of the

rudder. Use the ball-joint and pull-cable end, as shown, to hold the rudder horn in perfect alignment while

the glue dries. Clean up any excess glue with alcohol. Allow to dry.

A NOTE about servo arms on the 70" Slick. The Slick uses ball-links on its controls for precise control-

surface motion. It is extremely important to make sure that the ball-links have free motion throughout the

servo travel, and do not touch the servo arms. For example, when using Hitec servo arms, this is easily

accomplished by cutting or sanding away the corner of the arm as shown.