- ページ 10

おもちゃ 3D Hobby Shop Edge 540のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3D Hobby Shop Edge 540 17 ページ。

Measure the position of the horizontal stabilizer, front-to-back relative to the wing spar tube and also side-

to-side. The horizontal stabilizer should also be pushed forward tightly into its slot in the fuselage.

When you are satisfied that the stabilizer is straight, use thin CA glue as shown to attach it. NOTE: We

do not remove any covering on the stabilizer. CA glue bonds to covering material very well.

Install the elevator half with the elevator joiner rod. Slide the elevator into the stabilizer, make sure it

flexes easily at least 45 degrees up and down, and glue with 2 large drops of thin CA on each hinge.