- ページ 12
おもちゃ 3D Hobby Shop Edge 540のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3D Hobby Shop Edge 540 17 ページ。
ページを印刷する12
Attach a 12" inch / 300mm servo extension to the elevator servo. Use heat-shrink tubing or a servo-plug
lock on this connection. Install the elevator servo into the fuselage as shown. Install the pushrod adjustor
onto the servo arm. As before, do not fully tighten this nut, the adjustor must be able to rotate. Use thick
CA glue to lock this nut. After installation, the pushrod may be trimmed to length.
NOTE: Again, if you are unsure of the exact length of servo arm necessary, you can leave the adjustor
screw unlocked until after you have made sure your servo arm length is correct. Details of this will be
covered in the control setup section of the manual.