- ページ 4

コントロールユニット CubuSynth Exhaust V2のPDF ビルドマニュアルをオンラインで閲覧またはダウンロードできます。CubuSynth Exhaust V2 5 ページ。 Expander module for the engine v2
CubuSynth Exhaust V2 にも：ユーザーマニュアル (5 ページ)

ページを印刷する

CubuSynth Exhaust V2 - Build Guide

PCB V1.1 Jul 2023

STEP 3

Controls

Now take the Potentiometers, Jacks and switches and put them

in place as marked on the PCB but don't solder yet.

The switches should have one nut and one washer mounted like

shown here.

Below you can see the placement of all controls.

When everything is in place, put the front panel on top, so all

controls go into each corresponding hole of the panel. Make

sure everything fits well.

Fit all nuts to the Potentiometers, Jacks and switches.

Be careful when turning the board around, so that the components stay in place.

Then solder everything.

Page 4