CubuSynth Exhaust V2 Podręcznik budowy - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik budowy dla Jednostka sterująca CubuSynth Exhaust V2. CubuSynth Exhaust V2 5 stron. Expander module for the engine v2
Również dla CubuSynth Exhaust V2: Podręcznik użytkownika (5 strony)
Drukuj stronęCubuSynth Exhaust V2 - Build Guide
PCB V1.1 Jul 2023
STEP 3
Controls
Now take the Potentiometers, Jacks and switches and put them
in place as marked on the PCB but don't solder yet.
The switches should have one nut and one washer mounted like
shown here.
Below you can see the placement of all controls.
When everything is in place, put the front panel on top, so all
controls go into each corresponding hole of the panel. Make
sure everything fits well.
Fit all nuts to the Potentiometers, Jacks and switches.
Be careful when turning the board around, so that the components stay in place.
Then solder everything.
Page 4