- ページ 4

3Dプリンター 3D Systems ProJet 5000のPDF マニュアルをオンラインで閲覧またはダウンロードできます。3D Systems ProJet 5000 14 ページ。

One licensed copy of 3D Systems ProJet® Client Software with integrated online Help and Quick Reference Guide

Region-specific ProJet™ Production Printing System "country kit" consisting of:

One power cable kit for of a country-appropriate power, and a voltage warning document

One pack of nitrile gloves

One box of drip pans

05.0 Facility Guidelines

This section provides detail relating to site selection, site preparation and readiness of the facility to accept and install the ProJet™ Production

Printing System.

Discuss the appropriate equipment locations with a 3D Systems' representative, so that the equipment is located in a convenient, appropriate

location based on your organization's needs. When planning an installation, consider:

05.2 Access Area Surrounding Printers

05.3 Unit Portability

05.4 Electrical

05.5 Client Workstation Requirements

05.6 Network Interface

05.7 Material Storage

05.8 Material Bottle Disposal

05.9 Weights and Measures

Below is a suggested floor plan for a ProJet™ Production Printing System installation. Each printer requires use of a dedicated circuit. Multiple

printers CAN NOT be located on a single circuit. An additional 110 or 220 VAC outlet is recommended for service needs. A phone near the printer

is recommended to facilitate machine support. Each location of the machine requires a standard wall power outlet or power drop to power printer.

The outlet location must be near the printer and remain accessible to the end user at all times.

*NOTE: The ProJet Finisher XL has to be hard-wired in the facility. Ensure a certified electrician is required for installation.

A freezer is required for cooling parts after builds. The size of the freezer must be able to accommodate the build platform's size of 22 (L) x

16.25(W).

Dimensions (WxDxH)

Crated:

1828 x 1155 x 1981mm (72 x 45.5 x 78 inches)

Uncrated:

1531 x 908 x 1450mm (60.3 x 35.7 x 57.1 inches)

NOTE: The printer MUST be placed on a vibration free concrete floor. Do not install on any other floor covering such as

vinyl, tile, carpeting, etc.. Doing so WILL affect machine performance.

NOTE: The ProJet™ Production Printing System is not designed to connect to an IT system.