- ページ 6

3Dプリンター 3D Systems ProJet 5000のPDF マニュアルをオンラインで閲覧またはダウンロードできます。3D Systems ProJet 5000 14 ページ。

05.2 Access Area Surrounding Printers

At least 36" (908mm) of unobstructed floor space is recommended around each accomodate, to allow unobstructed service access to the

drawers, hood and doors.

Store crate where it will be easy access to wheel locks or have a jack lift available for the 3D Systems Field Engineers when installation

occurs.

NEVER unpack, assemble, or connect any component of the shipment without the aid of a qualified, 3D Systems Field

Service Engineer or authorized reseller. 3D Systems accepts no responsibility for damaged, defective, or incomplete

systems uncrated by anyone other than 3D Systems Field Service Engineer or authorized reseller.

The casters provided have a small diameter and are not intended for use on rough or uneven surfaces including deep

carpet.

To avoid the risk of tipping the printer when moving between locations, only push from the side of the printer.

The printer is intended to be lifted from its crate base using a fork lift device and place on casters to roll to its final

destination. Leveled fork lift pads have been placed beneath the machine to accommodate this need. The front and rear

guard panels must be removed prior to lifting.

The ProJet™ Printing System is equipped with four caster-type rollers, as well as four integral threaded feet. Leveling can be adjusted using the

threaded leveling feet, and tighten in place to secure the printer.

Once the printer is installed, it cannot be moved without the aid of a qualified, 3D Systems Field Service Engineer or

authorized reseller. 3D Systems accepts no responsibility for damage to the printer by anyone other than 3D Systems

Field Service Engineer or authorized reseller.