- ページ 5

TVマウント Displays2go HVAWM3260SのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Displays2go HVAWM3260S 5 ページ。

Swivel - Adjust the flat panel display for off-center viewing

positions. Grasp the side edges of the panel and then swivel it

into its desired position (Fig.11).

Panning - Position the flat panel display at an angle to the wall

for viewing from opposite sides of the room.

Grasp the side edges of the panel and then swivel and pull the

panel into desired position (Fig.12).

Portrait and Landscape-Before portrait and landscape viewing,

make sure the adaptor bracket have already tightened with

adaptor rail by 4 pcs slider plates, M6x12 screws and washers(Fig.13-1).

Loose the level screws (Fig.10-b),and rotate 90 degrees for portrait

and landscape viewing,then tighten the level screws.

NOTE: Do not fully loose the level screws for heavier panels.

Retracting the flat panel - Position the panel against the wall.

Grasp the side edge of the panel, swivel and pull it into the

center position (Fig.14). Then gently push the panel straight

back towards the wall into the retracted position (Fig.15).

NOTE : Use care when moving the panel to ensure that cables do not

become stretched or pinched. It is recommended that you allow a

small amount of slack in cables to allow for easy movement without

pinching.

The arm assembly and wall plate may be cleaned with a soft sponge and mild

solution of soap and water.

Caution : Be sure not to get moisture on the electrical connections or the panel.

1 : 5

Slider Plates

Fig. 13-1

M6*12mm

Metal Washer 6

Maintaining the HVAWM3260S

Fig. 11

Fig. 12

Fig. 13-2

Fig. 14

Fig. 15