- ページ 3

エンクロージャー 3D Upfitters AnkerMake M5のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3D Upfitters AnkerMake M5 18 ページ。

You Really Do Want to Read the Directions
Hey, we get it. You just got your new enclosure kit and want to start using it as fast as possible.
How hard can assembling a few plastic panels possibly be? It's not that hard, assuming you're
following the directions, but try to use brute force, and you'll end up working your way through
your vocabulary of swear words. While the acrylic pieces in the kit are strong, they are still
plastic and will break if bent far enough. The ghosts of the broken panels that have gone before
you have become much stronger than you could ever imagine and are whispering into your ear,
"just be a little careful."

Before you Start

Is This Manual for Your Kit?
This installation manual covers the enclosure design for the AnkerMake M5.
Is your Printer Customized?
If your printer is stock, then no customization is needed. If you have customized the printer,
you should examine any modifications to ensure they don't block the panels. If part of one of
the panels is blocked, you can use a laser or drill to customize one or more panels. This
should be done before removing the plastic or paper covers on the acrylic panels.
Cutting acrylic requires great care as the plastic is prone to crack if mishandled.
Preparing the Printer

Remove any filament from the hot end (which will require heating the hot end) and remove the
filament spool from the spool holder.
Turn the printer off and unplug the power cable from the printer's power supply.
Copyright 2023 3D Upfitters LLC
3