ページを印刷する16
been verified remove the control horn and apply a small amount of Welders glue or
super glue to the control horn and insert into slot in foam again making sure the hole in
the control horn is directly above the hinge line.
25. Use the 11'' graphite rod for the elevator. Using the same technique as used on the
ailerons, center the elevator servo and insure servo arm is located as close to center as
possible. Hook the pre made end of rod into the servo arm. Making sure servo is
centered and elevator control surface is centered and streamlined with the horizontal
stabilizer glue the z-bend to the carbon rod with super glue. Next heat shrink the
tubing over the carbon and wire again being very careful not to get to close to the foam
with the lighter.