3dEPP EPP Yak 55 Montaj Kılavuzu - Sayfa 16

Oyuncak 3dEPP EPP Yak 55 için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. 3dEPP EPP Yak 55 19 sayfaları.

been verified remove the control horn and apply a small amount of Welders glue or

super glue to the control horn and insert into slot in foam again making sure the hole in

the control horn is directly above the hinge line.

25. Use the 11'' graphite rod for the elevator. Using the same technique as used on the

ailerons, center the elevator servo and insure servo arm is located as close to center as

possible. Hook the pre made end of rod into the servo arm. Making sure servo is

centered and elevator control surface is centered and streamlined with the horizontal

stabilizer glue the z-bend to the carbon rod with super glue. Next heat shrink the

tubing over the carbon and wire again being very careful not to get to close to the foam

with the lighter.