ページを印刷する4. Repeat this process for the joints between the aft wing and forward side of aft
horizontal fuselage assembly and between the aft side of the aft horizontal fuselage
assembly and the forward side of the horizontal stabilizer and elevator assembly.
5. Next separate the upper & lower fuselage and, retain the center section. The area of
the servo from the center section can be used as a plug by cutting it off the center
section and gluing in it place with Welders glue on the lower fuselage. The same can be
done for the elevator and aileron servo which are located on the top fuselage. This is an
option if using dual aileron servos or if a different size servo is used however; we
recommend the HXT500 servo on all control surfaces.
6. Test fit top of fuselage to wing assembly to ensure tabs align. Leavening the rudder
hanging off end of table will aid in test fitting the upper fuselage assembly.
4