3dEPP EPP Yak 55 조립 설명서 - 페이지 4

{카테고리_이름} 3dEPP EPP Yak 55에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3dEPP EPP Yak 55 19 페이지.

4. Repeat this process for the joints between the aft wing and forward side of aft

horizontal fuselage assembly and between the aft side of the aft horizontal fuselage

assembly and the forward side of the horizontal stabilizer and elevator assembly.

5. Next separate the upper & lower fuselage and, retain the center section. The area of

the servo from the center section can be used as a plug by cutting it off the center

section and gluing in it place with Welders glue on the lower fuselage. The same can be

done for the elevator and aileron servo which are located on the top fuselage. This is an

option if using dual aileron servos or if a different size servo is used however; we

recommend the HXT500 servo on all control surfaces.

6. Test fit top of fuselage to wing assembly to ensure tabs align. Leavening the rudder

hanging off end of table will aid in test fitting the upper fuselage assembly.