- ページ 8
電源 Diverse GENIUS-IIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Diverse GENIUS-II 20 ページ。 Genius-ii power supply
ページを印刷する
Load, Battery and External DC Input Connections
All DC connections should be wired according to Figure 3 on page 11.
A block diagram of the basic internal wiring of the Genius-II can be found in
Figure 4 on page 14.
Wire Size
DC cables must be sized to carry the maximum full load current and to not exceed
the system volt drop requirements. The following cable sizes are recommended.
When running wires, if they pass through panels or wall, ensure the wires are
protected form damage by sharp edges. One option is to use cable glands.
Current
0 – 10 A
10 – 20 A
20 – 30 A
8
328 mm
316 mm
Figure 1: Mounting holes
Table 1: Wire Size Recommendations
Minimum Wire Size
1.0 mm² or 18 AWG
3.0 mm² or 14 AWG
5.5 mm² or 10 AWG