- ページ 6

クロスオーバー Alto AltoDrive2.3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Alto AltoDrive2.3 20 ページ。 Crossover digitale 2 way stereo digital x over
Alto AltoDrive2.3 にも：ユーザーマニュアル (19 ページ)

ページを印刷する

1. Password

Power SW with LED (1)

Turns the apparatus on and off. Press this SW, the power LED inside the SW will turn on.

Dial Control knob (5)

Used to change editable values.

3.2 The Rear Panel

AC INPUT

95-240V 60-50Hz

Rated Power Consumption 15W

FUSE:

210-240V: T315mAL 250VAC

95-120V: 500mA 250VAC

REPLACE FUSE WITH CORRECT

TYPE ONLY

Apparaten skall anslutas till

jordat uttag nar den ansluts

A102

till ett natverk

14.Input Connector for Input1 and Input2

15.Output Connector for Output1~Output4

16.MIDI Connector

17.Power Connector

Inputs (14)

These are XLR balanced connectors which connect to sources such as the channel inserts on mixing consoles.

They may be used with nominal input levels from consumer to professional audio.

Outputs (15)

LTO DRIVE2.3 has 4 outputs, they are XLR balanced connectors which connect to devices such as the channel

inserts on mixing console or power amplifier inputs .

MIDI Connectors (16)

-MIDI in: 5-poles DIN connector for the MIDI input to the

-MIDI thr: 5-poles DIN connector for the MIDI thr.

-MIDI out: 5-poles DIN connector for the MIDI output f om the

Power Connector (17)

This is an IEC 3-pole socket for connecting the AC power supply to the

4.INSTALLATION & CONNECTION

4.1 Power Up and Audio Connections

a. Audio Connections

The connections between the

cables so to prevent bad performances of the

shielded cables with a flexible internal conductor. Connect the cables to the

ving the following precautions:

Do not bundle audio cables with AC power cords.

Do not place audio cables and

formers, monitors, computers, etc.

Always unplug cables by firmly grasping the body of the plug and pulling directly outward.

Do not place cables where they can be stepped on.

Avoid twisting a cable or having it make sharp, right angle turns.

b. Power Up Setting

Before turning on the

All connections have been made correctly.

The volume controls of the amplifier or mixer are turned down.

Insert the Power plug into the POWER input on the rear panel of the

into an AC outlet.

Turn on the power of the

Turn on the power of the amplifier/mixer, and adjust the volume.

MODEL

MIDI

SERIAL

CODE

OUTPUT

THRU

INPUT

LTO DRIVE2.3 and the other audio devices have to be made using high quality

LTO DRIVE2.3 near sources of electromagnetic interference such as trans-

LTO DRIVE2.3's power, check if:

LTO DRIVE2.3, pushing the ON/OFF button on the front panel.

OUTPUT4

OUTPUT3

LTO DRIVE2.3.

LTO DRIVE2.3 itself. So it should be good to use low-capacitance

LTO DRIVE2.3 and plug the power cord

PUSH

NEW

TIDE

OUTPUT2

OUTPUT1

INPUT2

LTO DRIVE2.3.

LTO DRIVE2.3 properly by obser-

PUSH

NEW

TIDE

INPUT1