- ページ 7

ドローン 3DR ArduCopter Quad-CのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3DR ArduCopter Quad-C 19 ページ。

Arm Assembly x4

Note: If assembling a quad kit prior to Revision-C and installing 880kv (orange) motors the

centered hole on the arm that allows room for the shaft to poke through needs to be drilled out

to 10mm.

1. Attach the motor to the arm using two M3x5mm screws (Blue) and two M3 lock

washers (Orange) making sure the screws go into the threaded holes in the motor

and not the ventilation holes. (If the motor is screwed using the ventilation holes, it

will not spin freely) Route the motor cables through the hole on the side of the arm.

2. Use two M3x25mm screws (Green) and two M3 metal nuts (Pink) to fasten the legs

to the arm using the indicated holes. To provide rigidity to the legs attach two

M3x18mm spacers in between the legs and secure with four M3x5mm metal

screws (Blue).

3. Repeat for all 4 arms.